Kerry Podolsky <kwpodolsky@gmail.com>
1:04 PM (24 minutes ago)
to classics

I just received my SIO2PC board from Atarimax.
I installed the "trial" version of APE with ProSystem.
I plugged a REAL drive (D1) into the SIO but I couldn't seem to access the drive.
So, in reading further a post was asking about creating an ATR from a disk in the drive.
Your response was to use ProSystem.
Well, I tried ProSystem and it came up with the attached screenshot(1).


When I looked at my hardware devices, I see the attached screenshot (2).


What do I need to do, to get this to work with my computer?
Is there a special driver that needs to be installed?

And, I've even tried to MANUALLY update the USB driver with what is in APE For Windows\Drivers and... NG

No idea about windows 11 or the drivers.

But when you want to "see" the drive, you need to turn the atari ON to.
Somehow, the drive want's the "ready" line to be used.
That is what I experienced.
When both are on (drive and atari), ape works.

I use windows 10, and I can remember that I had to force windows to install a unsafe device.
But that is a loooooong time ago.

Grtz,
Sijmen.