Atarimax Product Discussion Forums https://atarimax.com/flashcart/forum/ |
|
MYIDE + Flash formatting CF issues https://atarimax.com/flashcart/forum/viewtopic.php?f=7&t=3982 |
Page 2 of 2 |
Author: | mr-atari [ Mon May 09, 2022 2:18 am ] |
Post subject: | Re: MYIDE + Flash formatting CF issues |
Hi Sylvester, Yes, that's right, HELP is the other way to enter the ide-menu. I want to help and create new files, but I can't. It's been too long ago and I have to dig too deep to get somewhere. Sorry. I noticed the menu.bin is 16k and that is not supported by the 1Mb+IDE..... Tried to parse it in 2x 8k, but that did not work either. So to have the menu's running for -RE you need to run SETUP to install them on the CF-card. Anything you want to add, just add it to the cartridge-menu. Just use SHIFT at power-up to enter the cartridge and load it. Grtz, Sijmen. |
Author: | dir_marillion [ Wed May 18, 2022 4:35 pm ] |
Post subject: | Re: MYIDE + Flash formatting CF issues |
Hi Sijmen, I am sorry, I didn't notice that you wrote something at the 2nd page.. That's why the delay. What about these questions ? 1. Also, when I try to make partitions, I can only make four of 65535 sectors (16MB) and actually the 4rth partition is a little bit lower sized (around 55.000) I think, whatever is the size of the CF 250MB or 1GB. Why ? 2. Still I can't make the CF to contain both Atari and FAT32 partitions. Thank you |
Author: | mr-atari [ Sun May 22, 2022 2:12 am ] |
Post subject: | Re: MYIDE + Flash formatting CF issues |
dir_marillion wrote: 1. Also, when I try to make partitions, I can only make four of 65535 sectors (16MB) and actually the 4rth partition is a little bit lower sized (around 55.000) I think, whatever is the size of the CF 250MB or 1GB. Why ? 2. Still I can't make the CF to contain both Atari and FAT32 partitions. 1, card is full, meaning, all allocate-able area for MyIDE_partitions is used. If less room is available then requested, the remaining room is assigned. 1+2, Read the manual, chapter "USING THE MYIDE-MENU" in the manual. In case you missed it, manual is here: viewtopic.php?p=7010#p7010 Success, Sijmen. |
Page 2 of 2 | All times are UTC - 5 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |